PWM with DSP 28335

I have a problem I created a small program using a DSP Spectrum pwm Dgital F28335, I attached a picture of the internal settings of VisSim Delfino F2833. My problem is that I see my pulse on the oscilloscope for this PWM and connect the tip of the oscilloscope to GPIO0_EPWM1A (PIN 9) and GPIO0_EPWM1B (PIN 10) and I can not see any PWM pulse on the oscilloscope. Please tell me if there is a problem in my configuration of the DSP or in my program VisSim. The DSP I'm using is the F28335 eZdsp.

Thank you.

OK, it works fine for us. We

OK, it works fine for us. We did make a small change. You did not turn on System > System Properties... > Run in Real Time
You also did not have Auto Restart enabled, so he diagram would only run for a short time, then turn off the MCU and put the PWMs in reset.
The attached file below has Run in Real Time, Auto Restart, and Retain State enabled. This should give you the PWM signals on your scope.

Ok, this is my program

Ok, this is my program VisSim.

Thanks

Sorry, but I don't see an

Sorry, but I don't see an attachment. You can send it to support@vissol.com if that is easier.

ok I will send you an email

ok I will send you an email with the program. vsm, my email is joga033@hotmail.com

Please attach your .vsm

Please attach your .vsm program.