plz do needful...i do not get the output..

Submitted by Yogesh K on Fri, 02/26/2016 - 06:16

i tried the sipmle induction motor control programm as per guidance ..but i couldnt get the output plz help me.. i attached the programm below...

thanks ..

‹ how to create while loop how to generate pulse of 10 microsec in vissim embedded.. ›
»

thanks sir..

Submitted by Yogesh K on Mon, 03/14/2016 - 00:22.

thanks sir..

VNIT

Yogesh,There were several

Submitted by pete on Fri, 03/11/2016 - 11:42.

Yogesh, There were several problems with your model.

  1. There was a disconnected gain after your PID that removed the controller from the loop
  2. You were bypassing the PID with another gain
  3. The Voltage Source Inverter was configured to toggle between 0 and 1, but needed to be -1 and 1 to give proper motor response.

The repaired model is attached below.