piccolo launchpad

Submitted by veeraputhiran on Wed, 12/04/2013 - 06:58

Hii.... please help me to use the blocks for piccolo launch pad.. i just need to glow a single LED... thanks

‹ Digital Power Documentation a model three-phase asynchronous motor squirrel-cage rotor type ›
»

To blink an LED you need two

Submitted by Anders89 on Wed, 12/04/2013 - 23:31.

To blink an LED you need two blocks: a square wave block to create the on-off signal and a GPIO write block. LED blink
Square wave block is under Blocks > Signal Producer > squareWave, GPIO write block is under Embedded > Piccolo > Digital/Analog output for F280x.

Sample diagram is attached. You must sign in to see it.

thank you so much sir

Submitted by veeraputhiran on Sun, 12/08/2013 - 20:18.

thank you so much sir

i saw all the examples... i

Submitted by veeraputhiran on Wed, 12/04/2013 - 22:27.

i saw all the examples... i want to know the minimum blocks to access a single GPIO... please need support..

We have a wide variety of

Submitted by Anders89 on Wed, 12/04/2013 - 14:50.

We have a wide variety of Launchpad examples under the VisSim menu: Embedded > Examples > Piccolo > Launchpad. The diagram blinkLaunchpad28027 will blink all 4 LEDs in a binary count sequence.