How do I burn my .out file to flash with CCS v4?

I have compiled my VisSim diagram and checked the flash option. How do I get my program burned to flash?

Interesting. What version of

Interesting. What version of CCS are you using? You can use the new CCS v5 with the latest download of VisSim/ECD.

Hi, I also want to burn an

Hi,
I also want to burn an .out file to flash, so I did what you said.
but now, I have a problem whith CCSv4.
At the last step, when I click Ok to burn the flash, I have this error message in the console:
C28xx: Loader: One or more sections of your program falls into a memory region that is not writable. These regions will not actually be written to the target. Check your linker configuration and/or memory map.
C28xx: File Loader: Data verification failed at address 0x003F7FF6 Please verify target memory and memory map.
Error found during data verification.
Ensure the linker command file matches the memory map.

I have selected the good f28035.gel, so I don't understand why it doesn't work
I join my diagram
Could you help me

Your diagram write to flash

Your diagram writes to flash fine in our labs. Are you sure you are loading the out file to the C28x target and not the CLA target? There are 2 cpu's on the 28035 and you can only burn the flash from the c28x cpu.

Yes This is what I've

Yes
This is what I've done:

  • I add a new target configuration
  • I choose the TMS320F28035 and the right F28035.gel
  • I Click on : Target > Launch TI Debugger
  • It launch a non project debug session. (I join a printscreen)
  • I Connect to target (Target > Connect Target)
  • Then I click Target > Load Program...
  • I choose my FlashProgramming.out
And I have the error.
Is there some configurations I forgot?

Strange. The failure is on

Strange. The failure is on memory addr 0x3F7FF6, which is legal flash memory on the F28035. Please post your flashprogramming.map file so we can check your memory placement. It could be that the flash is bad or had a nondefault password written on your part.

Here my FlashProgramming

Here my FlashProgramming complete project(. vsm, .c and .map) if you want to compile it yourself and compare with mine.

Your .map file is identical

Your .map file is identical to ours. Please try the attached .out file. It flashed to our F28035 target with no problems. It was built using your .vsm file.

Sorry, but it didn't work. I

Sorry, but it didn't work. I had the same problem.
I've also noticed something strange :
I downloaded the Example_28035_Flash CCS4 example from TI website and it work fine if I do 'Target > Debug Active Project'
But when I do 'Target > Launch TI Debbuger' and I try to load the same Example_28035_Flash.out, I had the error.
I think I have a problem with my Non-Project Debug Session

Interesting. What version of

Interesting. What version of CCS are you using? Our testing worked with v4.2 and v5.0.

Version: 4.2.4.00033

Version: 4.2.4.00033

To burn an .out file to flash

To burn an .out file to flash in CCS v4 do the following:

  • In CCS be sure that the target has been configured (Target > New Target Configuration)
  • Launch TI Debugger (Target > Launch TI Debugger)
  • Connect to target (Target > Connect Target)
  • Load the program (Target > Load Program…) and Browse… to the .out file
  • Click OK and the flash will program